Cargo Barrier Failure in Armored Car


John R. Yannaccone, PE, Senior Mechanical Engineer ::::
Case Synopsis: On a dark and foggy morning an armored car, occupied with a driver and guard, was transporting assorted monetary cargo. The guard was situated in a seat located in the rear cargo area. As the armored car was traveling down the road, the driver failed to see a stopped tanker and drove into its rear. Upon impact, the cargo in the rear of the armored car shifted forward and impacted the rear of the guard’s seat, driving him into the bulkhead separating the cargo compartment from the driver’s area. The guard sustained serious injuries resulting in partial paralysis.
Expert Analysis: Inspection of the armored car revealed that the damage to the guard’s seat was consistent with it being loaded from behind and deforming it forward. There was a small bar, intended to serve as a barrier, to prevent the cargo from shifting, which was heavily deformed and had separated from its mounting points, allowing the cargo to move forward during the crash. In addition to the inadequate strength of the barrier, the basic design of the low bar was not sufficient to prevent heavy cargo from getting to the guard seated in the cargo area.
As part of the analysis in this case, a cargo barrier of sufficient strength to prevent the maximum cargo load of the armored car was designed. Both the original and the alternative design cargo barriers were crash tested. The original design failed to prevent the cargo from impacting and heavily deforming the guard’s seat. The alternative barrier design kept the cargo out of the newly created guard’s compartment and protected the guard from injury. The testing demonstrated that there were feasible and cost-effective methods to prevent the cargo from causing injury to the occupants.
Result: Prior to trial, a settlement was reached with the defendants.
More information about this testing program can be found in SAE paper 2005-01-0879, Occupant Protection from Cargo in Armored Vehicles.
John R. Yannaccone, PE, Senior Mechanical Engineer with DJS Associates and can be reached via email at or via phone at 215-659-2010.

Categories: Armored Car

Tags: John R. Yannaccone | Mechanical Engineer


Have A Question About This Article or Want to Contact the Expert?

Request An Expert

Fill out the form below so we may refer an expert

Do you have a question for us? We’re here to help!

James Schmidt Expert Spotlight